[TUTO] How to install and configure picons on TEAMBLUE

Here is an image tutorial that shows you how to install and configure picons on Gigablue decoders under a TeamBlue image.

N.B: This tutorial is valid for all versions of  TeamBLue and Gigablue models

For this tutorial you need.

Material:

GiGaBlue HD800 Solo
GiGaBlue HD800 SE
GiGaBlue HD800 UE
GiGaBlue HD800 SE Plus
GiGaBlue HD800 UE Plus
GiGaBlue HD Ultra UE
GiGaBlue HD X1
GiGaBlue HD X3
GiGaBlue HD X3.H
GiGaBlue HD Quad
GiGaBlue HD Quad Plus
GiGaBlue UHD Quad 4K
GiGaBlue UHD UE 4K

 

Winscp for WINDOWS

 

PICONS 220 × 132 for satellite

– Launch WINSCP in the home window

File protocol: FTP

Hot name: 192.168.1.100 (ip address of your gigablue)

User name: root

Password: “empty” by default the root password in Teamblue is empty (no password needed)

After clicking on Login

Unpack the Picon ASTRA 220 × 132 file

Select the picon folder and drag between the two windows to the /usr/share/enigma2 folder.

MENU – Setup

System

User interface

Basic Settings

Enable Show picons in channel list

press GREEN button to save

Then restart your receiver

 

Congratulation you have Picon now on your TeamBLUE SKIN 🙂

*******************************************************************

You can install the picons on the internal flash memory of your receiver, the internal hard disk, a USB key

Command to add when copying picon to the internal hard drive

ln -s /usr/share/enigma2/picon /hdd/picon

Command to add when copying picon to USB stick

ln -s /usr/share/enigma2/picon/usb/picon

Leave a Reply

Your email address will not be published. Required fields are marked *