[HOW TO FLASH] how to flash Atemio AM 6100

The Atemio AM 6100 (also known as the Atemio 6100 HD) is the single-tuner sibling of the 6200. It is a Broadcom-based receiver that uses a very specific folder-based trigger for flashing.

Step 1: USB Preparation

• Format: The USB drive must be formatted to FAT32. (A high-quality 4GB or 8GB USB 2.0 stick is the most reliable).

• Folder Structure: When you unzip the image (e.g., OpenATV or OpenPLi), you will see a folder named atemio.

• Target Path: Inside the atemio folder, there must be a subfolder named 6100.

  • Path check: USB_DRIVE:\atemio\6100\

  • Crucial Files: Ensure it contains kernel.bin, rootfs.bin, and imageversion.

Step 2: The Flashing Procedure

1. Full Power Off: Switch off the receiver using the physical power switch at the back.

2. Insert USB: Plug the drive into the rear USB port.

3. Boot & Trigger:

   • Switch the rear power toggle to ON.

   • Watch the front panel display. When it displays “Found Image” or “Press OK,” quickly press the Power button on the front panel.

4. Wait for Progress: The display will show “Flashing” or “Updating.” This process usually takes about 3 minutes. Do not interrupt the power.

5. Reboot: Once the display says “Completed” or “Success,” the box will reboot. Remove the USB drive immediately to prevent it from entering the flash cycle again.