[HOW TO FLASH] how to flash ANADOL MULTIBOX Twin

The Anadol Multibox 4K Twin is a HiSilicon-based receiver that utilizes a Recovery Menu (Maintenance Mode) for flashing, similar to the AX Multibox models. It is highly flexible due to its Multiboot support (4 slots) and its Twin DVB-S2X tuners.

Step 1: USB Preparation

• Format: Use a high-quality USB 2.0 or 3.0 stick formatted to FAT32.

• The File: Download the “recovery” zip file for the Anadol Multibox Twin (e.g., OpenATV 7.x).

• Target Path: Copy the .zip file directly to the root of your USB drive. Do not unzip it.

Step 2: Accessing the Recovery Menu

1. Power Off: Turn off the receiver using the rear power switch.

2. Insert USB: Plug the drive into the USB 3.0 (blue) port on the side or rear.

3. The Trigger:

   • Press and hold the Power Button on the front panel.

   • While holding it, flip the rear power switch to ON.

   • Keep holding until the “Maintenance Mode” menu appears on your TV screen.

Step 3: Flashing the Image

1. In the menu, select “Flash local image”.

2. Navigate to your USB drive and select the .zip file.

3. Choose a Slot: Select one of the four available slots (e.g., Linux 1).

   • Note: Flashing to a new slot allows you to keep your current image safe in another slot.

4. Wait for the progress bar to reach 100%. Once completed, select “Boot” and choose the slot you just updated.

The flashing process should take approximately two to four minutes to complete, while the receiver
is being flashed it is vitally important that you DO NOT power the receiver down for any reason as
this can cause serious and or permanent damage.