[HOW TO FLASH] how to flash AMIKO Viper Combo HDD

The Amiko Viper Combo HDD is a unique Mipsel-based receiver that includes a dedicated internal bay for a 2.5″ hard drive. Because it uses the older Mipsel architecture (like the Slim and Twin), it follows the folder-naming trigger method for flashing.

Step 1: USB Preparation

• Format: The USB stick must be formatted to FAT32. For Mipsel boxes, a smaller, older USB 2.0 drive (4GB or 8GB) is often more reliable than a modern USB 3.0/3.1 drive.

• Folder Structure: When you extract your image (OpenATV, PurE2, etc.), you will see a folder named amiko.

• Target Path: Inside the amiko folder, there must be a subfolder named viper-combo-hdd.

  • Path check: USB_DRIVE:\amiko\viper-combo-hdd\

• Files: Ensure the folder contains kernel.bin, rootfs.bin, and imageversion.

Step 2: The Flashing Procedure

1. Full Power Off: Flip the physical power switch at the back of the receiver to OFF.

2. Insert USB: Plug the prepared USB stick into one of the USB ports (the rear port is typically recommended for flashing).

3. The Trigger:

   • Switch the rear power toggle to ON.

   • Immediately watch the front panel display.

   • As soon as the display shows “USB” or “UPDT”, quickly press the Power/OK button on the front panel.

4. Wait for Progress: The display will cycle through the flashing stages. This takes about 3–5 minutes. Do not interrupt the power during this process.

5. Finish: Once the display shows “Success” or the box reboots, remove the USB drive to prevent it from entering a flash loop.