[HOW TO FLASH] how to flash IQON 200 HD

To flash the IQON 200HD, you will follow the standard procedure for the IQON Broadcom series. Like its bigger brothers (the 300 series), the 200HD requires a specific folder name to trigger the update from a USB stick.

1. Preparation

• USB Stick: Use a high-quality USB 2.0 stick. 8GB or smaller is the “sweet spot” for this receiver’s bootloader.

• Format: The stick must be formatted to FAT32.

• Firmware: Download the image specifically for the IQON 200HD (OpenATV and OpenPLi are the most stable options for this model).

2. Folder Structure

The bootloader identifies the update through the iqon directory.

1. Extract the downloaded firmware .zip file.

2. You should see a folder named iqon.

3. Copy the entire iqon folder to the root of your USB stick.

   • Path: USB:\iqon\200hd\

   • Contents: Inside the 200hd subfolder, you should see files like kernel.bin, rootfs.bin, and imageversion.

3. The Flashing Process

1. Power Off: Turn off the receiver using the power switch at the back.

2. Insert USB: Plug the USB stick into the rear USB port.

3. Power On: Turn the back power switch to ON.

4. Initiate Flash:

   • Watch the front panel display closely.

   • When the receiver detects the valid files, it will display a message like “USB” or “Found Image”.

   • Immediately press the Power button on the front panel to confirm.

5. Wait: The display will show the progress (e.g., “FLSH”). Do not turn off the power during this time.

6. Completion: The receiver will reboot automatically once the flash is finished.

The flashing process should take approximately two to four minutes to complete, while the receiver
is being flashed it is vitally important that you DO NOT power the receiver down for any reason as
this can cause serious and or permanent damage.