[HOW TO FLASH] how to flash GI ET-7000 Mini
To flash the GI ET-7000 Mini, you will use a standard Enigma2 USB flashing method. While the image shows a generic Enigma2 guide, the steps below contain the specific details required for the ET-7000 Mini.
You must download the specific image file for the “et7000” or “et7x00” model.
Preparation
-
USB Stick: Use a high-quality USB 2.0 or 3.0 stick. Smaller capacities (e.g., 4GB–8GB) are recommended for better bootloader compatibility.
-
Format: Format the stick to FAT32 using a Full Format on your PC.
-
Image: Download your preferred image (e.g., OpenATV, OpenViX, or TeamBlue). Make sure the image is named explicitly for the et7000 or et7x00 (e.g.,
openatv-7.4-et7000mini-2024..._usb.zip). -
File Structure: Extract the
.zipfile. You will see a folder structure that must be copied to the root of your USB stick. The structure must look like this:-
USB_ROOT:\et7x00\noforce...(or similar, depending on the image and bootloader version). -
The critical folder
et7x00must be at the very top level of the USB drive.
-
Flashing Procedure
| Step | Action | Visual/Feedback |
| 1. | Power Off | Fully turn off the receiver using the physical power switch or by unplugging the power supply. |
| 2. | Insert USB | Plug the prepared USB stick into the USB port on the receiver. |
| 3. | Power On | Apply power to the receiver. |
| 4. | Flashing Mode | The ET-7000 Mini should automatically detect the image. On many ET-7000 models (including the Mini), the front panel LED will typically turn a steady PURPLE/LILAC (similar to image_0.png) or a distinct BLUE (image_4.png) while the flashing is in progress. The TV screen may also display “Flashing.” |
| 5. | Progress | The flashing process takes a few minutes. The LED will likely flash in a different pattern (or change color, e.g., to Green) once the process finishes. |
| 6. | Completion | When the flashing is complete, the box will automatically reboot into the new image startup wizard. You can then safely remove the USB stick. |
Troubleshooting Tips
-
Box Bypasses the USB: If the box boots normally to the old image, the most common issues are:
-
USB Stick Compatibility: Try a different, smaller, and older USB 2.0 stick.
-
Incorrect File Structure: Ensure the
et7x00folder is in the root and contains the correct files.
-
-
LED Feedback: ET-7000 models rely heavily on LED indicators during flashing. If the LED doesn’t change to Purple or Blue, the flashing is likely not triggered.
-
TV Prompt: Some images might display a message on the TV screen asking you to confirm flashing by pressing a button (this is less common on the ET-7000 Mini).
The flashing process should take approximately two to four minutes to complete, while the receiver
is being flashed it is vitally important that you DO NOT power the receiver down for any reason as
this can cause serious and or permanent damage.
