[HOW TO FLASH] how to flash Ariva combo
To flash the Ferguson Ariva ATV Combo (which runs on the Android/Enigma2 hybrid system), you will use the USB recovery method. This process is a bit more “Android-style” compared to older GI or GigaBlue boxes but is very reliable for enigma2.net readers.
Preparation
-
USB Stick: Use a high-quality USB 2.0 or 3.0 stick (FAT32 formatted).
-
Image: Download the recovery image (often named
update.zipor a folder structure likedinobot). -
File Structure: Extract the files. For the Ariva ATV Combo, you typically need the folder named
hi3798mv200(or similar, depending on the chipset) placed at the root of your USB drive.
Flashing Procedure
| Step | Action | Visual/Feedback |
| 1. | Power Off | Unplug the power adapter or use the rear switch. |
| 2. | Insert USB | Plug the stick into the USB 3.0 (blue) port for faster data transfer. |
| 3. | The Trigger | Use a paperclip to press and hold the Reset button (usually located in a small hole on the back or side). |
| 4. | Power On | While holding Reset, plug in the power. Keep holding it for 5–8 seconds. |
| 5. | Progress | Release the Reset button when the front display shows “UPDT” or the TV screen shows the “Upgrading” Android logo. |
| 6. | Finish | The box will reboot twice. Do not remove the USB until you see the Setup Wizard on your TV. |
The flashing process should take approximately two to four minutes to complete, while the receiver
is being flashed it is vitally important that you DO NOT power the receiver down for any reason as
this can cause serious and or permanent damage.
